Most replacement rear crossmembers, whether they are plain, with extension, or on a 1/4 chassis, have the top holes for the lifting eye 'missing', as they are covered over by the tub mounting tabs.
Only the lower hole visible, no hole in tab.
- SAM_1524.JPG (29.94 KiB) Viewed 2368 times
They are however present on the inner face of the rear crossmember.
Both holes visible.
- SAM_1525.JPG (29.54 KiB) Viewed 2368 times
The strengthening plate to stop the crossmember deforming when the lifting eyes are in use is present inside the crossmember. Well it is on mine anyway. If you poke around inside the holes should find the inner strenghtening plate to the outer side of the holes. All that you should need to do is drill the holes through the tabs as I believe they are there behind the tab. It certainly didn't feel like I was drilling through double thickness steel on the last two I drilled, but I wasn't paying much attention. Whether you chance drilling the hole in the right place through from the inner hole, or line up a lifting eye on the outside is up to you. Personally I'd line up a lifting eye to be sure.
Regards,
For Those That Have Had To Fight for It, Life Has Truly A Flavour The Protected Will Never Know.
'First my weapon. Then my equipment. Then myself.'
Neil.
09FM98. 1973 Ex SIII FFR Now 3.5 V8 LWT Coiler.
55HG98. 1980 SIII FFR PARA RECCE. Ex 1, 2 and 3 PARA.
Td5 90 XS.
