Today started unbolting the tub top panels, the nut plates have been removing themselves as the rivets are rotted off.
What I have found and didn't know is that the nut plates are cranked and the gaps were filled with a white, hard putty which initially through me into a panic thinking it was the dreaded corrosion of doom, but no, once cleaned up there was no corrosion at all

. With regards to the putty, I've come across this before with evidence it was used as a sealant on the Sankey hub ends and also one of the drive end plates when I replaced the rear hub oil seals. I believe it maybe boss white? The first pic shows traces of it on one of the plate;

- 006.jpg (3.81 MiB) Viewed 2372 times
Anyway, the two plates I have removed have cleaned up a treat;

- 007.jpg (167.68 KiB) Viewed 2372 times
More tomorrow.
Bob