What is that?

Any Land Rover related info can be posted here.
Post Reply
fifi929
Posts: 35
Joined: Fri Sep 13, 2024 2:28 pm
Location: Auvergne, france

What is that?

Post by fifi929 » Thu Aug 06, 2026 7:16 pm

Look down the front of the engine at the crankshaft pulley. You should see a metal plate with 3 pointers just above. There is a notch in the pulley rim which is TDC of the No. 1 cylinder.

Rotate the engine with the starting handle until the notch is in line with the 3rd pointer (furthest right) and the rotor arm points to the No. 1 cyl spark plug lead . This should have your engine at TDC and is a good position to set your contact breaker points just opening with modern fuels.

Having got the engine started and warmed up take it for a road test. Find a hill (not too steep) and drive up in 4th gear at low revs (don't labour the engine) under full throttle. If you hear a rattling sound - pre-ignition ('Pinking'), retard the timing a little. If you don't hear anything then you can try advancing the ignition a little until you do, then back off a bit.

If after a longer trip the engine runs on a little when you switch off the ignition, you probably need to retard the timing a tad more.

Remember the distributor shaft rotates ant-clockwise. So turning the distributor body anti-clockwise retards the timing, clockwise advances it.
IMG_20260806_093116.jpg
IMG_20260806_093116.jpg (3.8 MiB) Viewed 11988 times
IMG_20260806_093127.jpg
IMG_20260806_093127.jpg (3.76 MiB) Viewed 11988 times
IMG_20260806_095037.jpg
IMG_20260806_095037.jpg (3.21 MiB) Viewed 11988 times
IMG_20260806_095041.jpg
IMG_20260806_095041.jpg (2.68 MiB) Viewed 11988 times

Post Reply