Google translation is my best friend right now!
Actually 27G?77, because the VIN plate is damaged at this point and is therefore illegible.
This LWT FFR LHD comes from BAOR, is dated January 1977 and the contract number is: WV 11916.
It works very well since I traveled more than 600 km to 60 km / h average to go home with
At the beginning of 20017, I performed a complete disassembly by subassemblies to estimate the work; I decided to buy a new chassis (Richard Galv), the number of elements completely rotted by rust was too important.
It's an investment, a good starting point and I'll save time later.
Loulou was reconditioned in the BAOR workshops in 1986, the plates on the engine and the gearbox give good indications. The engine is in standard sized bore, the crankshaft is +0.10, the cylinder-head must be a "pre-Defender" lead-free but to check, the gearbox also works properly.
The lower part of the bulkhead (footwell?) Is damaged (it is traditional) and the vent-panel is not too pierced by rust. The seat-base is broken.
Since its acquisition in September 2014, I have regularly purchased quality spare parts (NOS + genuine + OEM) to spread the reconstruction costs as well as all the useful technical document and follow-up of the reconstructions of LWT on various forums. I think it is the best solution to finish this type of work very long.
I take this opportunity to thank you for all the tips and tricks available on your forum.
Since the fall of 2017, the entire transmission has been rebuilt: the front and rear axles and the two driveshafts. NTN bearings (fine adjustments to the comparator) TRW-Lucas and Mintex brake cylinders for linings, Corteco oil seal and new flange, brake drums are rectified, etc.
The most difficult was the front deck with new bowls and the mounting of the Railko to the press.
All seals on the gearbox have been changed, to repair the "output flanges", I will surely use SKF speedi-sleeve.
For the sunny season of this year (painting in the rain ...?), I'm going to work on the bodywork because there is a lot of work also to remake a lot of things correctly, straight, without oxidation of aluminum and without bumps.
The engine will be measured and rebuilt next winter.
In the end, Loulou will be repainted in deep bronze green satin (paint + hardener to mix) with a new FFR tarpaulin and the markings of "1st Armored Division" or "12th Armored Infantry Brigade", we will see well at this time.
I will put pictures of the progress of the site regularly (well, I hope I have the time ...
Thank you for your interest in this reconstruction.
Loulou.