..Well I do like a challenge!
Right so today I promised myself I would do two things:
1) clean up the casing of the steering box
And
2) finish repairing the tub floor
1 is currently in progress, as after a mild acid dip and a scrub, the casing is now in white spirit, to remove a few bits of underseal that some Dr Cackhands in the late 60s saw fit to spray all over it.
2 ... we'll I'm about 50% of my way through the welding. I've come in for a break, a drink and a battery charge as I've been using my portable drill with wire brush to clean off any oxidation before welding. It's slower, and therefore kinder to the aluminium than the equivalent grinder set-up.
Here is the section on the edge of the panel which had completely been eaten away. The brass backer is to act as a heat sink, and a convenient shaper for the liquid aluminium...

- IMG_4537.JPG (97.63 KiB) Viewed 1442 times

- IMG_4538.JPG (94.51 KiB) Viewed 1442 times
And here is the same section after basic filling in with the torch, and a light pass over with the flapwheel...

- IMG_4539.JPG (100.46 KiB) Viewed 1442 times
It still needs more filling, and the edge needs shaping, but I'll get to that later. I'm pleased though, that I've finally found some much more effective settings on the MIG.
I gave the panel a once over with etch primer before I came in. This is more of a confidence booster for me than anything else at the moment, as it has revealed only the bits still needing attention, while making the rest of the panel look much nicer and shiniererer.

- IMG_4540.JPG (125.16 KiB) Viewed 1442 times
I'll be back out in another hour or so to finish the job off. Then it will be a steering box and a tube of autosol in front of the telly to finish the day off
See you in a bit,
Andy