Thanks Adam - I'll try not to forget that by the time it comes to fit it!
So tonight's instalment is all about the damaged hub. One of the rear hubs I am waiting to fit to the rear axle (hopefully tomorrow) had quite extensive gouges to the face that mates to the drive member. This mean that the gasket would stand no chance of holding in the oil, and in fact when I bought the vehicle it had clear evidence of an oil leak on that side.
Also some buffoon, who may or may not have been me dropped a spinning grinder on it, breaking the grinder and further damaging the hub. Grr.
Enter cunning plan.
I decided to blob some weld onto each of the gouges in the face of the hub, then file, sand and grind (ok scratch that I don't have a grinder anymore) until the face was serviceable again.
Here's stage one:

- IMG_1031.JPG (74.08 KiB) Viewed 1938 times
Obviously stage two involved a lot more effort. I hand-filed the weld blobs for two hours before I got fed up, and after some rummaging found one of those rubber sanding attachments for my drill, together with a really coarse, evil looking sanding pad. Bingo.

- IMG_1032.JPG (73.87 KiB) Viewed 1938 times
Admittedly there is still a need for stage three: fill the two or three holes (there were originally twelve) remaining after sanding, and flap wheel the inside edge where weld has dribbled into the casing slightly. There will also be some final polishing needed over the whole face to make it perfect.
Still, I'm really pleased with the result, and I reckon it would already seal with the appropriate gasket and sealant.
I also did a bit more tidying, finding the massive socket set me and my dad bought to do up a mini in the nineties. Good times. Amazing what sentimental value can be found in a tool box.
What else have I done? Oh yes, I found about 400 spanners I forgot I owned, and dipped the rear diff casing in the acid bath ready for painting on Sunday. I also dipped one of the bulkhead brackets, as it occurred to me it's an easy part to get fitted, and one thing leads to another in that respect.
See you tomorrow for (hopefully) an axle rebuild. Finger crossed it won't be snowing by then..
All the best,
Andy