Series 2a wing set up

Any Land Rover related info can be posted here.
User avatar
StuWright
Master Baker
Posts: 1740
Joined: Wed Feb 24, 2016 11:10 pm
Location: Southampton

Series 2a wing set up

Post by StuWright » Fri Jan 06, 2017 1:30 am

Does anyone know or have any pictures of the set up for mirrors and aerial boxes on series 2a front wings?

Now I'm at the point of looking at fitting my new mirror arms I thought should check exactly where they should go. I can't find a single picture as reference.
Thanks

Stu

55AM52 Ex RAF Land Rover Lightweight GS

88lr
Posts: 285
Joined: Sat Jun 27, 2015 3:59 pm

Re: Series 2a wing set up

Post by 88lr » Fri Jan 06, 2017 1:28 pm

The mirrors are about 12" from the front of the wing and about 1" from the edge. If you look underneath your wings you should see the reinforcement brackets for the mounting hole (1 each side) The ATU goes in front of the mirror arm, the holes should be there for it.

njc21
Posts: 35
Joined: Wed Oct 14, 2015 3:08 pm
Location: Bedford

Re: Series 2a wing set up

Post by njc21 » Fri Jan 06, 2017 3:16 pm

Hi Stu,

Is this any help?

Sorry not my picture so apologies if i've caused any offence. :?

Regards,

Neil
Attachments
13 AA 93, 1974, 644 VGS, RAF Spitalgate.jpg
13 AA 93, 1974, 644 VGS, RAF Spitalgate.jpg (168.77 KiB) Viewed 3231 times

Gordon Bennett
Maître Pâtissier
Posts: 7422
Joined: Sun Jan 10, 2010 12:21 pm

Re: Series 2a wing set up

Post by Gordon Bennett » Fri Jan 06, 2017 4:15 pm

njc21 wrote:Sorry not my picture so apologies if i've caused any offence. :?
Hi Neil,

I hope that you don't mind, but it's a good time to use this as an example for all poster's. Sorry Stu for hi-jacking your thread, but this is very important.

Copyright is a serious issue. Even though, in the majority of cases, no harm was meant whatsoever.

If anyone posts a picture that they have found on the open Internet, then please state the following - 'Picture Courtesy of the Internet'.

If the picture is from a specific Website, group etc. then you should state the name of the Website where it came from -e.g. 'Picture Courtesy of the Military Lightweight Club'.

Be careful though, as in the Terms and Conditions of many Websites, including ours, it states that you MUST ask for the owner's permission before copying or reproducing any material.

Most people are happy for a picture to be used as long as they are given credit.

However, if you haven't given the appropriate credit and broken the Terms and Conditions, some people will rightly not be happy and will look at 'Breach of Copyright'.

So, no need for mass panic, just be careful and if you are not sure, drop me a PM and ask.

Kind regards,
Gordon

User avatar
StuWright
Master Baker
Posts: 1740
Joined: Wed Feb 24, 2016 11:10 pm
Location: Southampton

Re: Series 2a wing set up

Post by StuWright » Fri Jan 06, 2017 5:03 pm

I am always happy for my threads to get hijacked Gordon. ;)

Great picture by the way, although id anyone find one or a link to one with an aerial box it would be good. I never thought about it but haven't even seen a picture of a 2a with a wing box, although I am sure they did. I bet Bob will know.
Thanks

Stu

55AM52 Ex RAF Land Rover Lightweight GS

njc21
Posts: 35
Joined: Wed Oct 14, 2015 3:08 pm
Location: Bedford

Re: Series 2a wing set up

Post by njc21 » Fri Jan 06, 2017 5:20 pm

Hi Gordon,

Thanks for putting me straight. It always worries me when posting pictures like this, i will try and avoid next time or just add the suggested anotatation.

Regards,

Neil

User avatar
Bob Fell
Cake Guru
Posts: 3044
Joined: Wed Sep 18, 2013 7:17 am
Location: Melton Mowbray

Re: Series 2a wing set up

Post by Bob Fell » Fri Jan 06, 2017 6:29 pm

StuWright wrote:I am always happy for my threads to get hijacked Gordon. ;)

Great picture by the way, although id anyone find one or a link to one with an aerial box it would be good. I never thought about it but haven't even seen a picture of a 2a with a wing box, although I am sure they did. I bet Bob will know.
Sorry Stu but I am confused, your vehicle is a SIII yes?
Then why 2A wings?
Ok, on 2A wings with the Larkspur ATU boxes there was no requirement to reposition the mirror arms as the ATU box was much smaller.
However, the Clansman TUAAM cases are considerably larger and butt up very close to point of fouling the mirror arms so the mirror arms on the early SIII (they used the same 2A wings) had to be relocated rearward (not a problem on later SIII as the have door mounted mirrors). The GS instructions AC61590 Clansman Radio Installations in Trucks 1/2 and 3/4 ton, TUL and TUM, FFR and GS Rover, Part 7 Supplement 4, UK/PRC351/2 in GS only, detail the repositioning drilling requirement in chapter 1 p8 and fitting in chapter 2 p4 & 5. If you are only having one TUAAM station then there is only need to reposition the mirror arm on the wing it is to be mounted - see instructions. You may wish to reposition both though but it's up to you. Note requirement for reinforcing channel in table 1 p4. If you don't have them they can be easily be made op or sourced from the usual suspects. You have these instructions from me some time ago but I can re-send if you like.
You will be very pushed to find any pics of 2A's with Clansman fits, I never came across a 2A fitted with Clansman but that's not to say there weren't any.

Hope this helps.
Regards
Bob
042Bobf


19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.

User avatar
Tinweasel
Maître Pâtissier
Posts: 5280
Joined: Fri Mar 05, 2010 8:23 pm

Re: Series 2a wing set up

Post by Tinweasel » Fri Jan 06, 2017 6:32 pm

It's odd but having looked through both the old and new testament and can't see any exterea photos of a 2a with radio kit. However if you have Mark Cooks book there is a photo of a pre production version which shows to location of the mounting points. And at the back of claudio's book there is a small photo of a series 3 with larkspur antennas fitted along with wing top mirrors if either of those help?

Shaun
Image

Rudolf Hess was the editor of mine Kampf, so was he the first grammar nazi?

Tring, Hertfordshire

User avatar
longlegslandyman
Posts: 314
Joined: Sun Nov 15, 2015 11:54 am
Location: Herne Bay Kent

Re: Series 2a wing set up

Post by longlegslandyman » Fri Jan 06, 2017 6:46 pm

Here,s some dimensions but as stated above this is for a series 3 and for fitting the clansman wing atu box.
http://www.land-rover-lightweight.co.uk ... 0Box/L.jpg

User avatar
Bob Fell
Cake Guru
Posts: 3044
Joined: Wed Sep 18, 2013 7:17 am
Location: Melton Mowbray

Re: Series 2a wing set up

Post by Bob Fell » Fri Jan 06, 2017 6:57 pm

longlegslandyman wrote:Here,s some dimensions but as stated above this is for a series 3 and for fitting the clansman wing atu box.
http://www.land-rover-lightweight.co.uk ... 0Box/L.jpg
From Part 7, as per my post, thanks.

Regards
Bob
042Bobf


19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.

Post Reply