Series 2a wing set up
Series 2a wing set up
Does anyone know or have any pictures of the set up for mirrors and aerial boxes on series 2a front wings?
Now I'm at the point of looking at fitting my new mirror arms I thought should check exactly where they should go. I can't find a single picture as reference.
Now I'm at the point of looking at fitting my new mirror arms I thought should check exactly where they should go. I can't find a single picture as reference.
Thanks
Stu
55AM52 Ex RAF Land Rover Lightweight GS
Stu
55AM52 Ex RAF Land Rover Lightweight GS
Re: Series 2a wing set up
The mirrors are about 12" from the front of the wing and about 1" from the edge. If you look underneath your wings you should see the reinforcement brackets for the mounting hole (1 each side) The ATU goes in front of the mirror arm, the holes should be there for it.
Re: Series 2a wing set up
Hi Stu,
Is this any help?
Sorry not my picture so apologies if i've caused any offence.
Regards,
Neil
Is this any help?
Sorry not my picture so apologies if i've caused any offence.
Regards,
Neil
- Attachments
-
- 13 AA 93, 1974, 644 VGS, RAF Spitalgate.jpg (168.77 KiB) Viewed 3232 times
-
Gordon Bennett
- Maître Pâtissier
- Posts: 7422
- Joined: Sun Jan 10, 2010 12:21 pm
Re: Series 2a wing set up
Hi Neil,njc21 wrote:Sorry not my picture so apologies if i've caused any offence.![]()
I hope that you don't mind, but it's a good time to use this as an example for all poster's. Sorry Stu for hi-jacking your thread, but this is very important.
Copyright is a serious issue. Even though, in the majority of cases, no harm was meant whatsoever.
If anyone posts a picture that they have found on the open Internet, then please state the following - 'Picture Courtesy of the Internet'.
If the picture is from a specific Website, group etc. then you should state the name of the Website where it came from -e.g. 'Picture Courtesy of the Military Lightweight Club'.
Be careful though, as in the Terms and Conditions of many Websites, including ours, it states that you MUST ask for the owner's permission before copying or reproducing any material.
Most people are happy for a picture to be used as long as they are given credit.
However, if you haven't given the appropriate credit and broken the Terms and Conditions, some people will rightly not be happy and will look at 'Breach of Copyright'.
So, no need for mass panic, just be careful and if you are not sure, drop me a PM and ask.
Kind regards,
Gordon
Re: Series 2a wing set up
I am always happy for my threads to get hijacked Gordon.
Great picture by the way, although id anyone find one or a link to one with an aerial box it would be good. I never thought about it but haven't even seen a picture of a 2a with a wing box, although I am sure they did. I bet Bob will know.
Great picture by the way, although id anyone find one or a link to one with an aerial box it would be good. I never thought about it but haven't even seen a picture of a 2a with a wing box, although I am sure they did. I bet Bob will know.
Thanks
Stu
55AM52 Ex RAF Land Rover Lightweight GS
Stu
55AM52 Ex RAF Land Rover Lightweight GS
Re: Series 2a wing set up
Hi Gordon,
Thanks for putting me straight. It always worries me when posting pictures like this, i will try and avoid next time or just add the suggested anotatation.
Regards,
Neil
Thanks for putting me straight. It always worries me when posting pictures like this, i will try and avoid next time or just add the suggested anotatation.
Regards,
Neil
Re: Series 2a wing set up
Sorry Stu but I am confused, your vehicle is a SIII yes?StuWright wrote:I am always happy for my threads to get hijacked Gordon.![]()
Great picture by the way, although id anyone find one or a link to one with an aerial box it would be good. I never thought about it but haven't even seen a picture of a 2a with a wing box, although I am sure they did. I bet Bob will know.
Then why 2A wings?
Ok, on 2A wings with the Larkspur ATU boxes there was no requirement to reposition the mirror arms as the ATU box was much smaller.
However, the Clansman TUAAM cases are considerably larger and butt up very close to point of fouling the mirror arms so the mirror arms on the early SIII (they used the same 2A wings) had to be relocated rearward (not a problem on later SIII as the have door mounted mirrors). The GS instructions AC61590 Clansman Radio Installations in Trucks 1/2 and 3/4 ton, TUL and TUM, FFR and GS Rover, Part 7 Supplement 4, UK/PRC351/2 in GS only, detail the repositioning drilling requirement in chapter 1 p8 and fitting in chapter 2 p4 & 5. If you are only having one TUAAM station then there is only need to reposition the mirror arm on the wing it is to be mounted - see instructions. You may wish to reposition both though but it's up to you. Note requirement for reinforcing channel in table 1 p4. If you don't have them they can be easily be made op or sourced from the usual suspects. You have these instructions from me some time ago but I can re-send if you like.
You will be very pushed to find any pics of 2A's with Clansman fits, I never came across a 2A fitted with Clansman but that's not to say there weren't any.
Hope this helps.
Regards
Bob
042Bobf
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
Re: Series 2a wing set up
It's odd but having looked through both the old and new testament and can't see any exterea photos of a 2a with radio kit. However if you have Mark Cooks book there is a photo of a pre production version which shows to location of the mounting points. And at the back of claudio's book there is a small photo of a series 3 with larkspur antennas fitted along with wing top mirrors if either of those help?
Shaun
Shaun

Rudolf Hess was the editor of mine Kampf, so was he the first grammar nazi?
Tring, Hertfordshire
- longlegslandyman
- Posts: 314
- Joined: Sun Nov 15, 2015 11:54 am
- Location: Herne Bay Kent
Re: Series 2a wing set up
Here,s some dimensions but as stated above this is for a series 3 and for fitting the clansman wing atu box.
http://www.land-rover-lightweight.co.uk ... 0Box/L.jpg
http://www.land-rover-lightweight.co.uk ... 0Box/L.jpg
Re: Series 2a wing set up
From Part 7, as per my post, thanks.longlegslandyman wrote:Here,s some dimensions but as stated above this is for a series 3 and for fitting the clansman wing atu box.
http://www.land-rover-lightweight.co.uk ... 0Box/L.jpg
Regards
Bob
042Bobf
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.