Page 1 of 1
Drivers side footwell replacement
Posted: Sat May 03, 2025 4:00 pm
by Devon13
Hello there, have to replace the footwell which was unexpected to say the least. I have removed most items apart from a few things on the left hand panel. Having trouble finding the spot welds on the left to take it out completely and thinking rather than install the complete foot well to cut around the the rot on the left side and , cut out appropriately from the new one and slightly over lap? Any thoughts please. I can’t weld so either need to pop rivet it or get someone to come and weld it.
Re: Drivers side footwell replacement
Posted: Sat May 03, 2025 9:00 pm
by AR4412
Hi Mark,
The spotwelds can be hard to see as they can be faint, and depending on the layers of paint on the bulkhead, almost invisible. I attacked mine with paint stripper and a wire wheel in a drill to reveal them so that they could be drilled out. Although I only replaced the toe boards and the hinge panels, not the inner firewall panel as fitted to the footwell you have purchased.
Hopefully these pics will help a bit.
This first one shows where all the spotweld were on the outside of the toe board to hinge panel. Although this is the passenger side it is just a mirror of the driver's side. The red line shows where a seam weld is that will need to be cut through to release the panel. This seam weld also extends over the hinge panel.

- SAM_1655.JPG (60.13 KiB) Viewed 3276 times
There is the same seam welding on the bottom of the panel holding it to the main bulkhead channel and hinge panel.

- SAM_1806.JPG (53.12 KiB) Viewed 3276 times
In this picture below, the red line shows where you will find a row of approximately 14 spotwelds all spaced roughly 30-35mm apart. The yellow line shows a row of 7 spotweld in the front of the panel. Spacings are the same. The green line a row of five spotwelds on the inner face of the gearbox tunnel panel. Again, spacings are the same.

- SAM_1678.JPG (64.91 KiB) Viewed 3276 times
Regards,
Re: Drivers side footwell replacement
Posted: Sat May 03, 2025 10:25 pm
by Devon13
Thank you Neil, that’s a great help