Page 1 of 1
Electrical Coolant and Oil Temp Guages
Posted: Wed May 17, 2023 4:51 pm
by AlbertaBoy
Can you get electrical replacements for the Capillary gauges that don’t cost silly money, or am I in the wrong game rebuilding my “Triggers Broom” Lightweight
Re: Electrical Coolant and Oil Temp Guages
Posted: Wed May 17, 2023 8:08 pm
by AR4412
You can replace the capillary gauge combined cluster with the later electrical combined gauge, in fact IIRC there was a complete conversion kit to do so, but it is a fairly straight forward DIY job. You will need a pair of temperature sensors, (IIRC the coolant and oil ones are the same), and you will need an adaptor for the temperature sender to fit the cylinder head, and one to fit the thermo pocket. The adaptors are the standard ones for an electrical temperature sender on the 2 1/4 petrol. You will need to run a piggy back twin wire to feed to the gauges from the fuel gauge's original ignition feed Green wire, and then run a wire from each gauge to the appropriate sender.
Regards,
Re: Electrical Coolant and Oil Temp Guages
Posted: Wed May 17, 2023 10:07 pm
by AlbertaBoy
Thanks - best place to buy them/ part numbers?
Re: Electrical Coolant and Oil Temp Guages
Posted: Thu May 18, 2023 8:06 am
by AR4412
The senders are Part No. 560794, the adaptors are Part No. 568457, unless you have a later metric head fitted then it is ERC8973 to fit the coolant sender. These should be widely available, but haven't had chance to look. The combined cluster is Part No. PRC1776 for a 12 volt vehicle, PRC1777 for the 24 volt vehicle. Again, available, but I would suggest sitting down before checking the prices for a new unit.
Regards,
Re: Electrical Coolant and Oil Temp Guages
Posted: Thu May 18, 2023 3:36 pm
by AlbertaBoy
Many thanks