Strange fuel gauge readings

If you have encountered or solved a problem post here
User avatar
gunner59
Posts: 67
Joined: Sat Apr 28, 2018 12:42 pm

Strange fuel gauge readings

Post by gunner59 » Sat Sep 19, 2020 8:15 am

So up until today have been running up young Gromit (85KA17) with just a small amount of fuel in the right hand tank and without the senders for either tank hooked up to the fuel gauge. But today, being finally satisfied with engine trials, I decide to connect them up and that would then only leave my with the IR and 6 way switches to sort on the instrument panel.

So, with the changeover tap in the middle position the fuel gauge reads what I would have expected for the RH tank. When I move the tap handle over to the right the gauge goes to zero. And when I move it over to the left it appears to try and give a minus reading. With the tap in the middle position if I disconnect either tank sender the gauge goes to zero.
With some fuel in both tanks and the tap in the middle position the gauge shows less than what is in the RH tank but about what is in the LH tank.

Help :!: :?:
85KA17 - 1982 Lightweight GS, 50 Missile Regiment Royal Artillery BAOR

12KJ74 - 1990 Defender GS, 1/2/3/ Gurkha Rifles Hong Kong Garrison

Undated narrow track Sankey trailer, chassis plate stamped 1229RN

User avatar
AR4412
Maître Pâtissier
Posts: 8938
Joined: Thu Sep 22, 2011 9:31 am
Location: Bedford

Re: Strange fuel gauge readings

Post by AR4412 » Sat Sep 19, 2020 11:46 am

With the fuel change over tap in the central position I would expect the fuel gauge to read the same as when the ignition is off, as there is no path to earth from the gauge through the switch and sender without a plunger being depressed. If there is a reading on the gauge with the tap in this position and the ignition on, there may be a short to earth somewhere in the wiring, or a plunger in a switch has stuck.

Check that the plungers are not stuck in the sender switches, they should protrude by about 3mm or so. IIRC they go in by about 2mm when pushed in by the tap on mine, But, it was a long time ago when I did them. I set mine up with the ignition on, adjusting them downwards until they break the circuit without 'bottoming out'. Their height can also be set using a multimeter.

Try removing the green/black wires from the switches, if the gauge gives any reading with the ignition on, then the wire from the gauge to the tap switches, or the gauge itself could be shorting to earth. If the gauge reads zero with ignition on then the fault is possibly with one of the switches. With the tap in the central postion, so that neither switch plunger is pressed in, and the wires from the tank senders removed, connect the Green/Black wire to one of the switches and observe the gauge for movement, then try the other. If the needle moves up when connected to a switch it could be that that switch is earthing out inside.

Linking the Green/Black wire direct to earth/battery negative should have the gauge reading maximum, and is a quick way to check that the circuit to the tap switches is okay.

Linking the Green/Black wire to either of the sender wires should read the level in that tank. (Or nothing if the sender unit is faulty or not earthing.).

Regards,
For Those That Have Had To Fight for It, Life Has Truly A Flavour The Protected Will Never Know.

'First my weapon. Then my equipment. Then myself.'

Neil.

09FM98. 1973 Ex SIII FFR Now 3.5 V8 LWT Coiler.
55HG98. 1980 SIII FFR PARA RECCE. Ex 1, 2 and 3 PARA.
Td5 90 XS.

User avatar
gunner59
Posts: 67
Joined: Sat Apr 28, 2018 12:42 pm

Re: Strange fuel gauge readings

Post by gunner59 » Thu Sep 24, 2020 11:13 am

Many thanks I'll give that a go this weekend. Weather forecast seems to be indicating a brief return to winter so I'll be "forced" to work in the garage. Shame that.
85KA17 - 1982 Lightweight GS, 50 Missile Regiment Royal Artillery BAOR

12KJ74 - 1990 Defender GS, 1/2/3/ Gurkha Rifles Hong Kong Garrison

Undated narrow track Sankey trailer, chassis plate stamped 1229RN

chipbury
Master Baker
Posts: 1411
Joined: Sun Oct 02, 2011 3:26 pm
Location: Bath

Re: Strange fuel gauge readings

Post by chipbury » Thu Sep 24, 2020 12:17 pm

gunner59 wrote: ↑
Thu Sep 24, 2020 11:13 am
Many thanks I'll give that a go this weekend. Weather forecast seems to be indicating a brief return to winter so I'll be "forced" to work in the garage. Shame that.
Since fitting a wood burning stove in my garage I find myself 'forced' to be tinkering in there whenever the temperature drops :D
2A - 39 FG 70

User avatar
Keith
Pastry Chef
Posts: 865
Joined: Wed Apr 29, 2015 9:40 pm
Location: Ayrshire

Re: Strange fuel gauge readings

Post by Keith » Tue May 25, 2021 11:29 am

Having read the above posts on "wonky fuel sender readings" I have a similar issue..
The Fuel gauge correctly shows a full tank when the sender float is at full position BUT, the fuel gauge only shows a half tank when the sender float is at empty position. I cannot get either sender to show empty on the fuel gauge. The fuel gauge only shows dead empty when the ignition is off.
Any ideas would be very grateful


Keith
Close Protection Officer
VIP transport, travel & accommodation

ScarboroughSeadog
Posts: 7
Joined: Tue Mar 07, 2023 4:06 pm

Re: Strange fuel gauge readings

Post by ScarboroughSeadog » Tue Mar 07, 2023 4:22 pm

Keith wrote: ↑
Tue May 25, 2021 11:29 am
Having read the above posts on "wonky fuel sender readings" I have a similar issue..
The Fuel gauge correctly shows a full tank when the sender float is at full position BUT, the fuel gauge only shows a half tank when the sender float is at empty position. I cannot get either sender to show empty on the fuel gauge. The fuel gauge only shows dead empty when the ignition is off.
Any ideas would be very grateful


Keith
I've got exactly the same problem, Keith. Did you get anywhere with a solution??

User avatar
fv1620
Bake Off Judge
Posts: 2268
Joined: Thu Oct 06, 2011 2:16 pm
Location: GB-CMN (formerly UK91)
Contact:

Re: Strange fuel gauge readings

Post by fv1620 » Tue Mar 07, 2023 6:25 pm

Not sure if it is the same questioner, but I have just posted this on HMVF. I'll put it here as it seems an issue often crops up.

I would be suspicious that your fuel gauge is incorrect or not earthed. The reason that 24v gauges require no stabilising voltage is that these gauges have two windings. One winding to pull the needle to empty & another winding to pull needle to full. These work in opposition depending on the fuel level but as both are energised by the same supply both windings are subject to the same voltage fluctuations.

12v gauges have a single winding so are voltage dependant & require that 10v stabiliser. Although the stabiliser is merely a thermal switch going on & off the erratic output is smoothed by the inertia of thermal gauge which responds slowly.

If you do have the correct 24v gauge bear in mind it has three connections. One to supply, one to the sensor & earth.
Clive Elliott

Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.

ScarboroughSeadog
Posts: 7
Joined: Tue Mar 07, 2023 4:06 pm

Re: Strange fuel gauge readings

Post by ScarboroughSeadog » Tue Mar 07, 2023 8:47 pm

0B6B6248-472D-4F27-8D3C-ADA6EA7D241B.jpeg
0B6B6248-472D-4F27-8D3C-ADA6EA7D241B.jpeg (1.89 MiB) Viewed 2448 times
Thanks Clive- same questioner!
It’s the correct 24V part- direct part number replacement for the old one.
It has (and should have I believe) only 2 connections to the gauge itself- the cluster housing is earthed.
I’ve just noticed that the gauge reads full when the tank switch is in the middle (selecting neither tank). Pretty sure it should read zero. Any thoughts if that points to a particular fault?

User avatar
fv1620
Bake Off Judge
Posts: 2268
Joined: Thu Oct 06, 2011 2:16 pm
Location: GB-CMN (formerly UK91)
Contact:

Re: Strange fuel gauge readings

Post by fv1620 » Tue Mar 07, 2023 9:25 pm

For those not on HMVF, my reply:

Thre are two coils there at 90 degrees to each other. To work correctly it should be earthed at the case (red arrow)
Gauge earth.jpg
Gauge earth.jpg (49.64 KiB) Viewed 2445 times
Fuel tank sensor resistor on the right.
Fuel gauge.jpg
Fuel gauge.jpg (75.58 KiB) Viewed 2445 times
Clive Elliott

Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.

User avatar
AR4412
Maître Pâtissier
Posts: 8938
Joined: Thu Sep 22, 2011 9:31 am
Location: Bedford

Re: Strange fuel gauge readings

Post by AR4412 » Wed Mar 08, 2023 8:49 pm

Hiya Clive! :D ,

That's a good diagram. I've not seen that before, so thank you for sharing it.

Regards,
For Those That Have Had To Fight for It, Life Has Truly A Flavour The Protected Will Never Know.

'First my weapon. Then my equipment. Then myself.'

Neil.

09FM98. 1973 Ex SIII FFR Now 3.5 V8 LWT Coiler.
55HG98. 1980 SIII FFR PARA RECCE. Ex 1, 2 and 3 PARA.
Td5 90 XS.

Post Reply