Right so after a mostly family time weekend, I managed to repair my welder and do a bit of a test weld on a smaller bit.. that orrible gearstick.
I had bought a replacement on the bay of e, but when It arrived I realised that while it was a double kink, it wasn’t quite as double kinky as the original double kink, and besides it doesn’t have a threaded top.
It did however have a much better castle thingy than the original gouged number:

- CC952862-BC9E-4A5D-818A-D5E74E8323A3.jpeg (904.61 KiB) Viewed 2218 times
I decided that rather than over-kink the less kinky stick, and preferring not to have to cut a thread into the top of it, I would fix the old one properly. First the previous owner’s repair was ground off, along with a channel around the circumference at the base just above where the stick meets the ball. This allowed me to bend and manipulate the stick to correct for the fact that:
a) It was bent over to the passenger side, meaning I’d have to be Larry Longarms to reach reverse gear
and
b) It was also sloping backwards too much above the ball section.
I couldn’t really get this combined misalignment to show up on camera, but trust me it looked a sight.
Weld ground off and stick ground thinner to aid bending:

- 8B74CFA7-EECC-4C82-8DF9-55A03E7958FE.jpeg (932.16 KiB) Viewed 2218 times
Stick straightened, welded up, evaporust-dipped and given a coat of paint:

- 9A59C808-BAED-4211-99C8-FFE788D52B52.jpeg (658.04 KiB) Viewed 2218 times
Other bits ready to go on:

- D7F4787E-ED97-4BB7-BD85-AADE318B7F05.jpeg (1.77 MiB) Viewed 2218 times
I’ve also stripped, dipped and painted the bracket that mounts it all to the top of the gearbox, but there's an image limit, and I’m not doing a whole extra page just for that so you’ll have to imagine it
I also cleaned up and painted the longitudinal steering rod but you can wait to see that until it has its rod ends fitted. We are not, after all, animals.
...and so, with excuses exhausted and welder fixed, the very next job will be some bulkhead welding! Yaaaaay!..... Hello? Is anyone still out there? Ah shucks.
All the best,
Andy