Page 1 of 1

24V FFR Welding: electrical system prep

Posted: Tue Feb 17, 2026 11:37 am
by ScarboroughSeadog
I need to replace the chassis outriggers under the footwells.

The seat box warning plate advises to disconnect the batteries (at + and - terminals presumably) and the generator before welding. I'm loath to disconnect the generator for various reasons, but if this is absolutely necessary then presumably it has to be done at the genny connection (not at the panel)?

Various advice is that so long as the weld clamp (earth) is right next to the part being welded, then disconnection is not required.

Grateful for advice on that point specifically (I won't be doing the welding, but the welder may not be familiar with the FFR set up)

Thanks

Re: 24V FFR Welding: electrical system prep

Posted: Tue Feb 17, 2026 12:23 pm
by finnbear270
I am a retired welder, having had many years experience on all sorts of stuff, Incl from warships to lawnmowers, :lol: as to vehicles, the comment "get the earth clamp as close as you can", if not on the part being welded. I have never had a problem with this way of working, That said, I wouldn't be doing such on anything modern such as Beemers / Audi or similar. :)

Re: 24V FFR Welding: electrical system prep

Posted: Tue Feb 17, 2026 2:08 pm
by AR4412
Just removing the battery negative lead will suffice, no need to unplug the generator to carry out any welding.

Regards,

Re: 24V FFR Welding: electrical system prep

Posted: Tue Feb 17, 2026 3:26 pm
by ScarboroughSeadog
Great stuff- thanks both.

Re: 24V FFR Welding: electrical system prep

Posted: Fri Jul 31, 2026 10:10 am
by sickpup
AR4412 wrote: ↑
Tue Feb 17, 2026 2:08 pm
Just removing the battery negative lead will suffice, no need to unplug the generator to carry out any welding.

Regards,
Glad you said that. I forgot to disconnect the generator the last time I welded and was worried about that.
I hope you're right :oops:

Re: 24V FFR Welding: electrical system prep

Posted: Fri Jul 31, 2026 7:50 pm
by AR4412
I haven't fried any alternators or generators yet. There's time yet mind you, I'm still relatively young.

Regards,

Re: 24V FFR Welding: electrical system prep

Posted: Sun Aug 02, 2026 9:44 am
by sickpup
Thank you for that confident comment :lol: