Page 1 of 1
Instrument panel removal & refurb
Posted: Sat Oct 11, 2025 9:27 am
by Devon13
Morning, I am trying to disconnect everything so I can take out the instrument panel but having difficulty with the cold start cable & the water temperature & oil temperature gauges. Is the only way to remove the cold start cable by disconnecting at the carb & pulling the cable through the bulkhead & then panel. Ref the temp gauges , I can’t pull them out or unscrew them, is that because they are rusted in or is there another method to disconnect them. Any advice would be much appreciated.
Re: Instrument panel removal & refurb
Posted: Sat Oct 11, 2025 10:49 am
by AR4412
Hi Mark,
The choke cable will need removing from the carb and pulling through the bulkhead before removing the cold start switch and then the cable from the panel.
The temperature gauges you have are the Bourden tube, or capillary type, which has a tube from the gauge to a bulb at the other end. To remove them with the dash panel requires their other ends to be removed from the engine. Easier to undo the two screws holding each of the gauges to the combined cluster. If the gauges work, take care not to damage them or the tubes as they are expensive to replace. If they don't work, it may be worth the time to 'upgrade' to the later electrical gauge cluster.
Regards,