6 way switch with ignition barrel

If you have encountered or solved a problem post here
Post Reply
airportableffr
Posts: 104
Joined: Tue Apr 24, 2018 9:56 am

6 way switch with ignition barrel

Post by airportableffr » Fri Jun 03, 2022 9:33 pm

can you use the 6 way light switch that has the ignition barrel 39293 fv706683, as a normal switch- ? (ie just don't fit the ignition barrel) - they seem a bit cheaper at the moment compared to the other types

diffwhine
Posts: 389
Joined: Sun Feb 25, 2018 9:28 pm

Re: 6 way switch with ignition barrel

Post by diffwhine » Sat Jun 04, 2022 9:26 am

I can't see why not, the wiring is the same as far as I am aware.
Those switches are not impossible to overhaul with a bit of patience and an evening at the kitchen table if that's a better option.

airportableffr
Posts: 104
Joined: Tue Apr 24, 2018 9:56 am

Re: 6 way switch with ignition barrel

Post by airportableffr » Sat Jun 04, 2022 3:30 pm

thanks

yes I have repaired the one I have to get me.by while I look for replacement. everything can be cleaned up and adjusted apart from the silver alloy spindle in the centre which gets eaten by the detent ball if too tight or just old..

Macvfork
Pastry Chef
Posts: 717
Joined: Sun Aug 17, 2014 3:31 pm
Location: Heathfield, sussex

Re: 6 way switch with ignition barrel

Post by Macvfork » Sun Jun 12, 2022 7:23 am

Hello
From memory they are just the same except for a couple of bits copper on the reverse.Remove if you wish. Change over the knobs and all appears the same. Stand corrected but think the important difference in switches is the method of connecting wires to the switch terminals as two variants.
85-KB-13 S3 lwt. Nato green GS ex 1LI, 40 RM
03-GF-35 S3 air portable DIS 1/75 ex NIM (V), 41 Cdo RM, RE, RCT, AMB SQN
300Tdi Disco 1 com for Rtv trials.

Post Reply