Page 1 of 1

New front prop shaft

Posted: Fri Feb 19, 2021 9:15 am
by greyleaf
Hi,
I need to refurbish/replace the front prop shaft on my series 3.
If I need to replace it the ones from the usual suspects appear to be different from the one fitted as in no rubber sleeve is fitted, paddocks https://www.paddockspares.com/stc121-f ... -4cyl.html show it with the sleeve, famous four https://www.famousfour.co.uk/new_parts ... t?part=262 shows it without Blanchard has no picture!. Are the ones without a sleeve the same item and do I need to buy a sleeve to fit?

Re: New front prop shaft

Posted: Sat Feb 20, 2021 12:58 pm
by Oneandtwo
I bought a new front from paddocks 12 months ago. It has no rubber gaiter, just rubber seal, and was made in India; previously I have bought them from paddocks and have been GKN ones so was a bit disappointed however, it has no play in the splines and was relatively cheap, and was better than the old one which was on there.

Re: New front prop shaft

Posted: Mon Feb 22, 2021 10:46 pm
by greyleaf
I bought a new front from paddocks 12 months ago. It has no rubber gaiter, just rubber seal, and was made in India; previously I have bought them from paddocks and have been GKN ones so was a bit disappointed however, it has no play in the splines and was relatively cheap, and was better than the old one which was on there.
Thanks for that.
I have the prop shaft off now no play in the u/j’s and very very slight play in the splines I can’t seem to make it rattle like it did when it was fitted, I’ll need to go for a run and see if the rattles gone. Thanks again