Page 1 of 1
Trailer and bridgeplates
Posted: Fri Feb 21, 2020 5:17 pm
by Fossibear
Hi,
can someone tell me wether trailers have their own bridgeplates or does the bridgeplate of the towing car does change?
Bye, Steve
Re: Trailer and bridgeplates
Posted: Fri Feb 21, 2020 6:38 pm
by Bob Fell
Hi Steve,
Simple answer is sometimes. If you look at illustrations at the beginning of the parts and technical handbooks, a bridge plate is clearly shown positioned o/s tub front.
In service pics sometimes show them, others not. What the criteria was, if any, I do not have a clue. I have checked the NT parts book but cannot find the plate listed although only cursory so may have missed it. My original trailer tub showed no evidence - the telltale 2 or 3 holes for the mounting bolts - of one being fitted. You will also see pvc decal plates but I do not know how correct they would be on an NT but at a guess wrong, my only experience of these were the Admiralty Grey ones on the cab fronts of our MK Bedfords in the 80's and early 90's.
So if you want to run with it, go for the steel plate and it'll be right for the period. Clive published a number of articles regarding vehicle markings that can be found on the EMLA site and very much worth a read for accuracy of markings etc.
That's the best I can advise.
Regards
Bob
Re: Trailer and bridgeplates
Posted: Fri Feb 21, 2020 8:54 pm
by fv1620
Bit of a can of worms, because someone screwed up the interpretation of NATO Standard STANAG 2010.
Equipment Regulations 1959 Pam. No.9 Marking & painting of vehicles, Army aircraft & equipment
Section 22 Bridge Classification signs STANAG 2010
"....and trailers with a rated capacity of 1 1/2 tons or less will carry the bridge classification signs."
Materiel Regulations for the Army 1975 Vol. 2 Vehicles & technical & warlike stores. Pam. No.3 Marking & painting of vehicles, Army aircraft & equipment
Section 605 Bridge Load signs STANAG 2010
"....and GS trailers of 1 1/2 tons or greater are to carry the bridge load classification signs."
Joint Service Road Transport Regulations JSP 341
Section 1243
" ...and trailers of more than 1 1/2 tons capacity are to display classification signs which indicate the load they will impose on a structure."
Re: Trailer and bridgeplates
Posted: Sat Feb 22, 2020 6:55 am
by Fossibear
Hi Bob, hi Clive,
Ok, thank you very much!
I will search some pictures and look around - I have just a copy of the Technical Handbook and the picture there isn’t clear enough.
And some time ago I found a picture which showed a Land Rover which had a bridgeplate in front wich showed a 2 and a 1 under another and there was written, that the 2 was for the towing car and the 1 for the trailer??? I can’t find this picture again.
And if I put a bridgeplate to the trailer - what’s to be written on it: „3/4“ ?
Still with some questions,
Yours, Steve
Re: Trailer and bridgeplates
Posted: Sat Feb 22, 2020 11:08 am
by fv1620
Steve it depends on:
What trailer you have
What era you want to represent
What theatre you want to represent
Just to muddy the water further, the trailer below still has the markings that it had in service plus the auction lot number. It has three features that are contrary to what was prescribed, depending on the era it is presented as. Can anyone get all three?

- IMAG0409.jpg (1.01 MiB) Viewed 16216 times
Re: Trailer and bridgeplates
Posted: Sat Feb 22, 2020 11:56 am
by Fossibear
Ok Clive,
I think I do understand, what you mean.
My Lightweight looks on a first sight like 2a but is a 3 from 1976.
The Sankey NT should be from 1968
The history tells me, that my car served with the 2 Coldstream Guards between 1978 and 1980 and with the 1 Coldstream Guards then till 1982.
It’s just a coincidence but I am interested in the Coldstream Guards because they were part in fights to free my homeland in 1945.
That would mean, that I should have to look, in which theatre those Regiments were in the years between 1978 an 1982...
Fact is, that I restored my Lightweight in dark bronce green and that I will not paint it over in some camouflage pattern. Also I will do with the Sankey.
So I am not quiet sure but I think, that I want to come to original as far as possible but my greater interest lies in my wish to have a car and a trailer wich satisfy my eyes (ifyou know what I mean

)
So nevertheless I try to find out, where the 2 Coldstream Guards were from 1978/80.
Thanks a lot for your for thoughts,
Steve
Re: Trailer and bridgeplates
Posted: Sat Feb 22, 2020 12:03 pm
by Fossibear
... if I found it right both Regiments were in Northern Ireland from 1969 till 2007 ?
Have they been there all the time because there is written: „numerous tours„
Steve
Re: Trailer and bridgeplates
Posted: Sat Feb 22, 2020 3:47 pm
by removeduser185
The 2nd Battalion Coldstream Guards were based in The Barracks, Caterham between April 1978 and December 1980. While there it is quite possible that they took part in a number of tours of NI, though they had spent the previous two years in Ebrington Barracks, Londonderry as a resident battalion. They were disbanded in December 1993.
Regarding the 1/2 ton trailer. Very odd and I'm not entirely convinced the markings are as they were in service. The main reason is the absence of the NATO electrical socket which, by the time black/green camouflage was introduced would surely have replaced the previous pattern (whose name I have forgotten). There were no Lightweights built with this type of socket, so that means the NATO type goes back to at least the second half of the sixties. Secondly, the black of the green and black camouflage appears to be covering part of the auction number, suggesting that it has been applied subsequently.
But, if it is genuine then, to answer Clive's point: yellow bridge circle with black and green camouflage is wrong, a white tyre pressure marking on green and black camouflage is wrong and the fact that a trailer is camouflaged in green and black is wrong. But, of course, that is not to say that each of these did not appear at some time on in-service vehicles, singly or together.
If I were you, Steve, I wouldn't add a bridge circle to the trailer. I don't remember seeing them, certainly not yellow ones on trailers during the time you are seeking to replicate. And I wouldn't add a number to the bridge circle on the Land Rover either. There stopped being a requirement to mark bridge classifications on light vehicles probably before that time and, apparently bridge circles stopped being added to new-build Land Rovers in the mid-seventies, although there are plenty of photos to suggest otherwise. But, grilles often fell off and so would be replaced from elsewhere and, it is quite possible some units thought that there should be a bridge circle and so fitted them and so on and so on. I have even seen a good photo of a 1 tonne Land Rover fitted with a lightweight grille!
Re: Trailer and bridgeplates
Posted: Sat Feb 22, 2020 4:47 pm
by Fossibear
Hi Fred,
Thank you very very much for your answer!
Well, I think, that I leave as it is and the trailer won’t get a bridgeplate.
But it is interesting how different different regiments worked with their equipment.
I remember a friend of mine who worked with the MP as translater. He told me that the German railway- men always were very astonished what stuff had been welded to tanks to put some material like camou- nets in them if it went to some manoeuvre. Problem often was, that the tanks were to broad for the railroad - no problem - a big Hammer and everything was ok

.
Thanks a lot again for helping me to find some answers!
Steve