What have you done to or with your LWT today??

Any Land Rover related info can be posted here.
Treehugger

Re: What have you done to or with your LWT today??

Post by Treehugger » Fri Oct 12, 2018 12:38 pm

Thanks for the part number. I telephoned Blanchard's today. Neck end of £70 for a pair of original spec seals. The cheaper version were only £6 cheaper. Ouch! Methinks they see me coming!

User avatar
the landy man
Cake Guru
Posts: 3080
Joined: Wed Sep 28, 2011 1:00 pm
Location: BOGNOR REGIS

Re: What have you done to or with your LWT today??

Post by the landy man » Wed Oct 17, 2018 6:13 pm

Just taxed my lightweight for another year!!
And declared it MOT exempt :D
So simple....but.... I look after my vehicles and it will be subject to an independent inspection when I see fit!
The Sand lightweight has to wait untill the 4/4/2019 before it comes out the garage!
..ROD..
Bognor Regis,West Sussex


1972 S3 LIGHTWEIGHT 53 AM 74,RAF GS .Waddington strike command
1979 LIGHTWEIGHT 10 GX 11,GS .Black watch 1st battalion
1964 SERIES 2A..
Sankey narrow track,29 EN 84
Sankey narrow track project.
1967 BSA b40 WD 350cc.
1957 Triumph 6T Thunderbird.

Treehugger

Re: What have you done to or with your LWT today??

Post by Treehugger » Wed Oct 17, 2018 8:44 pm

Today I completed the drivers side wheel hub with a new swivel hub (very expensive and chromed too. I could see my face in it. Not a pretty sight though), oil seals (several assorted sizes), stub axle land (easy peasey when you know how. Wasn't before I was told how to do it though. Bit scary actually first time.), wheel cylinder, solid short brake pipe, brake shoes and gator replacement and then reassembly. The hub was leaking oil and the gator had split so it had to be done.

Only have to refill the hub with oil and bleed the brake system to complete the work. I will do it when I have completed the entire front end work. Still got the nearside swivel hub replacement to do in the same way as the drivers side plus new track rod, drag bar and 4 x track rod ends and then refill the axle with oil. That will happen tomorrow and should be a piece of cake provided I don't hit any snags or the weather is crap.
Then its off to get it MOT on Monday all being well. Already completed the rear axle and hubs and they only need brakes bleeding which I will do in one job lot with the front. Any advice on brake bleeding gratefully accepted as its years since I've done any. Can't have changed that much though.

User avatar
removeduser185
Cake Guru
Posts: 3531
Joined: Thu Jun 18, 2015 10:37 pm

Re: What have you done to or with your LWT today??

Post by removeduser185 » Wed Oct 17, 2018 9:07 pm

the landy man wrote: ↑
Wed Oct 17, 2018 6:13 pm
Just taxed my lightweight for another year!!
And declared it MOT exempt :D
:D X! I hope I shall be following you next year!

chipbury
Master Baker
Posts: 1411
Joined: Sun Oct 02, 2011 3:26 pm
Location: Bath

Re: What have you done to or with your LWT today??

Post by chipbury » Thu Oct 18, 2018 5:46 pm

Fitted a new alternator as mine failed on Tuesday.

A bit of a saga as I was going to collect a mill/drill machine that I had been given for free. I drove 30miles to my parents where it started ok, then went to collect someone and it wouldn't turn over at all - luckily I was parked on a hill so bumped it in reverse and went to collect the machine. Once loaded up I had to hand start it and drove back to my parents where we checked the running voltage and it was 9.75v :shock: .
Anyway I had no real choice but to drive the 30miles home so after 10miles I stopped and checked the running voltage again which was still 9.75v. This must have been the voltage the alternator regulator had failed to. Everything worked ok at this voltage for the remaining 20miles home (shows that the Lumenition optical ignition setup is quite happy with a low voltage).
I got a unit on ebay for £49.90 ordered on Tuesday afternoon and delivered Wednesday - fitted today and all is ok.

What makes this long winded story more annoying/comical (time is a great healer) was that on Monday the alternator failed on the main car as well! That was a more expensive fix :? .

Cheers,

Chris
2A - 39 FG 70

Landie68
Master Baker
Posts: 1564
Joined: Sat Dec 03, 2016 6:31 pm
Location: Herefordshire

Re: What have you done to or with your LWT today??

Post by Landie68 » Thu Oct 18, 2018 5:53 pm

Repaired the damage incurred on Sunday (see 15FM83 posts), and also finally got around to rewiring the original heater, so given a wet day when my services can't be required in the garden, I shall be re-installing it.
Regards
Richard

Discovery Sport
15FM83 ex 15 Para and 7 PO's

User avatar
Tinweasel
Maître Pâtissier
Posts: 5280
Joined: Fri Mar 05, 2010 8:23 pm

Re: What have you done to or with your LWT today??

Post by Tinweasel » Fri Oct 19, 2018 1:59 pm

Well I have just driven to the test center to get another years ticket on it so fingers crossed.....
As I was about to pull in the cab started filling with smoke from the steering column shroud, fingers crossed that's a good sign.

As a side note, dishwashers are good for dishes and fantastic for car parts, you can even cook salmon in them, obviously don't do the salmon at the same time as the car parts. However don't use them for wooden chopping boards, the solid ones are ok, but the ones that are glued together....not so much!

Shaun
Image

Rudolf Hess was the editor of mine Kampf, so was he the first grammar nazi?

Tring, Hertfordshire

User avatar
hibbo
Bake Off Judge
Posts: 2430
Joined: Tue Jun 14, 2011 6:36 pm
Location: Gatwick west sussex

Re: What have you done to or with your LWT today??

Post by hibbo » Fri Oct 19, 2018 4:48 pm

Come on then the test must be done by now.
Graham.

Gatwick, west Sussex

Buy British, now it's more important than ever.

1980-83 GS Lightweight 57KB99
Sankey narrow track 08ES81
1942 350cc Ohv Ariel W'ng dispatch bike

User avatar
Tinweasel
Maître Pâtissier
Posts: 5280
Joined: Fri Mar 05, 2010 8:23 pm

Re: What have you done to or with your LWT today??

Post by Tinweasel » Fri Oct 19, 2018 5:04 pm

hibbo wrote: ↑
Fri Oct 19, 2018 4:48 pm
Come on then the test must be done by now.
Well I have just had a phone call from the test center, apparently the test went really well up to the point they started the engine, when more smoke escaped.

This has taken the smoke levels below the minimum safe level, and they hadn't anymore in stock to get the level back up, thankfully they have another delivery next week and the test can be done then.

Shaun
Image

Rudolf Hess was the editor of mine Kampf, so was he the first grammar nazi?

Tring, Hertfordshire

User avatar
hibbo
Bake Off Judge
Posts: 2430
Joined: Tue Jun 14, 2011 6:36 pm
Location: Gatwick west sussex

Re: What have you done to or with your LWT today??

Post by hibbo » Fri Oct 19, 2018 9:18 pm

Make sure it's genuine Lucas smoke, the Chinese stuff is crap.
Graham.

Gatwick, west Sussex

Buy British, now it's more important than ever.

1980-83 GS Lightweight 57KB99
Sankey narrow track 08ES81
1942 350cc Ohv Ariel W'ng dispatch bike

Post Reply