23HF14
- removeduser185
- Cake Guru
- Posts: 3531
- Joined: Thu Jun 18, 2015 10:37 pm
Re: 23HF14
Given the Welsh weather was making the previous look just a bit impractical, I thought I'd go for the "Northern Ireland look" for a while. I must say, the bikini top is rather good - fresh air and no door to bang your elbow on without flies in thr face or my wig blowing off!
- Attachments
-
- IMG_0570.JPG (2.04 MiB) Viewed 2192 times
- fv1620
- Bake Off Judge
- Posts: 2268
- Joined: Thu Oct 06, 2011 2:16 pm
- Location: GB-CMN (formerly UK91)
- Contact:
Re: 23HF14
Don't forget the sandbags on the floor!
Clive Elliott
Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.
Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.
Re: 23HF14
Hiya Fred
Your wagon is brilliant, what a gem
Credit to you, but how you live, or drive, with the 'suicide mirrors' God alone knows.
Best regards and keep safe.
Bob
Your wagon is brilliant, what a gem
Credit to you, but how you live, or drive, with the 'suicide mirrors' God alone knows.
Best regards and keep safe.
Bob
042Bobf
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
Re: 23HF14
Congratulations, very nice vehicle.
Many hours of work I imagine…?
Best regards.
Looloo
Many hours of work I imagine…?
Best regards.
Looloo
27GJ77 - 1977 LWT SIII FFR - 1st. Royal Horse Artillery - B Battery (BAOR)
- removeduser185
- Cake Guru
- Posts: 3531
- Joined: Thu Jun 18, 2015 10:37 pm
Re: 23HF14
Thanks, both. Overall, it's pretty good, but i'd make a better job of it if I were doing it again. I know the pitfalls now. I had a bit of a fiddle today. Firstly, I replaced the driver's side fuel tank which was leaking with a spare I had which also leaked, but only through a couple of pin holes which I have filled with fuel-proof putty. I hope that works - the holes were quite high up so will not be too vulnerable most of the time, whereas the one I have taken off must be holed quite low down - I have yet to find where. I put a little petrol in and left it over night and there was no seepage, so it should be OK. What did shock me, though, when I took it off was how rusty the bottom tray was. Bearing in mind that only three years ago I had cleaned all the rust off, treated it with Aquasteel rust preventer, primed it, painted it with several coats of paint and chip resistant coating, none of it counted for anything - it simply scraped off in sheets to reveal the rusty steel underneath. So much for my restoration skills - I'm glad I have a galv chassis as, otherwise, I would have treated it in the same way with, presumably, the same results.
Then I topped up the steering relay. It was weeping so I used one-shot. A bit of a fiddle getting it in - I had to resort to using a hypodermic syringe in the end, but it should be better than the oil.
Then I topped up the steering relay. It was weeping so I used one-shot. A bit of a fiddle getting it in - I had to resort to using a hypodermic syringe in the end, but it should be better than the oil.
- removeduser185
- Cake Guru
- Posts: 3531
- Joined: Thu Jun 18, 2015 10:37 pm
Re: 23HF14
f
Not brilliant photos, but better than simple words, I suppose. Today I did what I have been meaning to do for a while and that is go over the wheel arches with schulz. I liked the clean look, but, it wasn't authentic and when driving along bits of grit used to bang noisily on the insides. Hopefully this will now look more authentic and it may be a bit quieter when driving on the lanes around here.
Next job will be to get it over the pit and do a thorough check of bolt tightness underneath as well as topping up oils. It has done about 500 miles now since it was rebuilt so a general dig round seems to be a useful thing to do.
Next job will be to get it over the pit and do a thorough check of bolt tightness underneath as well as topping up oils. It has done about 500 miles now since it was rebuilt so a general dig round seems to be a useful thing to do.
Re: 23HF14
Hi Fred,
That looks really good. I use Dinitrol 4941 which gives as close a finish as you can get to the original under body sealant.
The plus is it's a damn slight easier to get off if you need to.
Best,
Bob
That looks really good. I use Dinitrol 4941 which gives as close a finish as you can get to the original under body sealant.
The plus is it's a damn slight easier to get off if you need to.
Best,
Bob
042Bobf
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
Undercoating
So what does everyone think of undercoating? I cannot get a straight answer online. Some say it is the worst thing you can do as it traps rust. Others say it is great. I have Rustoleum Rubberised Undercoating in a can, but am scared to apply it as it is a permanent application.
I want the protection under the tub and wheel arches. The sound deadening benefit is a big bonus. I have two Lightweights that I am combining into one... the one that had thick bitumen (applied by the RAF I guess) had little to no rust on the struts that support the underside of the tub. The struts on the other vehicle without the bitumen coating were eaten away. So that tells me bitumen works great.
What does everyone think? Perhaps with all the Birmabright undercoating is less of an issue than with steel bodied vehicles?
I want the protection under the tub and wheel arches. The sound deadening benefit is a big bonus. I have two Lightweights that I am combining into one... the one that had thick bitumen (applied by the RAF I guess) had little to no rust on the struts that support the underside of the tub. The struts on the other vehicle without the bitumen coating were eaten away. So that tells me bitumen works great.
What does everyone think? Perhaps with all the Birmabright undercoating is less of an issue than with steel bodied vehicles?
- removeduser185
- Cake Guru
- Posts: 3531
- Joined: Thu Jun 18, 2015 10:37 pm
Re: 23HF14
In a break between the showers (monsoon?) it seemed that a quick trip up the mountain was called for. Family walked up, I took the spare coats, some glasses and a bottle of wine to enjoy with spectacular views across the valley, none of which are evident here! Oh well!
it was a lovely drive - quite short really but enjoyable and the Land Rover had plenty of go. A good result.
Re: 23HF14
Hi Fred,
really lovely - how good, that you found a pause in the monsoon
Exactly the right terrain for cars like ours!
Regards, Steve
really lovely - how good, that you found a pause in the monsoon
Exactly the right terrain for cars like ours!
Regards, Steve
It's supposed to look like that, it's crochet...