No main beam

If you have encountered or solved a problem post here
Post Reply
Wizzlon
Posts: 34
Joined: Sat May 25, 2019 6:39 pm

No main beam

Post by Wizzlon » Sun Jan 05, 2025 6:03 pm

Interesting- A problem arose in that I only had dipped beam (unless I pulled the indicator stalk back- so bulbs were OK). Continuity checked them anyway..... Checked the rotary switch- visual check OK. Checked the indicator stalk- looked OK but added WD40. Result- Smoke from that switch assembly! Ordered a non original assembly to find I needed to do a bit of work- the original has 2 connection blocks- one of 5 and one of three pins (but 4 wires). But the new has the 5 pin block but not the 3- it has 4 individual wires with spade terminals. So, there was a bit of work that you need to plan for including working around the fact that the colour codes don't all correspond. Once done, the problem was solved and the horn is actually audible! £16 repair vs buying an original switch with the correct terminal blocks for £150 or (if you can find one). You can also see the jewel beam warning light on the speedo!

Cheers,

Andrew.

Post Reply