New front prop shaft

Any Land Rover related info can be posted here.
Post Reply
greyleaf
Posts: 208
Joined: Fri Jul 15, 2016 8:54 pm
Location: Warrington

New front prop shaft

Post by greyleaf » Fri Feb 19, 2021 9:15 am

Hi,
I need to refurbish/replace the front prop shaft on my series 3.
If I need to replace it the ones from the usual suspects appear to be different from the one fitted as in no rubber sleeve is fitted, paddocks https://www.paddockspares.com/stc121-f ... -4cyl.html show it with the sleeve, famous four https://www.famousfour.co.uk/new_parts ... t?part=262 shows it without Blanchard has no picture!. Are the ones without a sleeve the same item and do I need to buy a sleeve to fit?
Thanks
Graham

1974 LWT 24v FFR 33GB11

Oneandtwo
Posts: 242
Joined: Sun Nov 09, 2014 7:53 am

Re: New front prop shaft

Post by Oneandtwo » Sat Feb 20, 2021 12:58 pm

I bought a new front from paddocks 12 months ago. It has no rubber gaiter, just rubber seal, and was made in India; previously I have bought them from paddocks and have been GKN ones so was a bit disappointed however, it has no play in the splines and was relatively cheap, and was better than the old one which was on there.

greyleaf
Posts: 208
Joined: Fri Jul 15, 2016 8:54 pm
Location: Warrington

Re: New front prop shaft

Post by greyleaf » Mon Feb 22, 2021 10:46 pm

I bought a new front from paddocks 12 months ago. It has no rubber gaiter, just rubber seal, and was made in India; previously I have bought them from paddocks and have been GKN ones so was a bit disappointed however, it has no play in the splines and was relatively cheap, and was better than the old one which was on there.
Thanks for that.
I have the prop shaft off now no play in the u/j’s and very very slight play in the splines I can’t seem to make it rattle like it did when it was fitted, I’ll need to go for a run and see if the rattles gone. Thanks again
Thanks
Graham

1974 LWT 24v FFR 33GB11

Post Reply