lightweight tyres

Any Land Rover related info can be posted here.
Post Reply
dougall
Posts: 4
Joined: Mon Oct 12, 2020 11:30 am

lightweight tyres

Post by dougall » Mon Nov 02, 2020 10:40 am

hi all,
could anyone give me info on what is the correct tyres to put on my 72 lightweight please.

User avatar
removeduser185
Cake Guru
Posts: 3531
Joined: Thu Jun 18, 2015 10:37 pm

Re: lightweight tyres

Post by removeduser185 » Mon Nov 02, 2020 6:34 pm

dougall wrote: ↑
Mon Nov 02, 2020 10:40 am
hi all,
could anyone give me info on what is the correct tyres to put on my 72 lightweight please.
First of all, welcome to the forum. Do introduce yourself and tell us about your Lightweight - and we DO like photos!

As for tyres I am not an expert, but this is my understanding of the situation: Well, it is a problem because the original tyres are now very difficult to source as they are no longer made and, as every year goes by, those which can be found become less reliable as the rubber deteriorates and begins to crack. These original tyres were crossply tubed tyres on 5.00Fx16 well-based rims. The size was 6.50x16 and by far the most common tyre used was the Goodyear Xtragrip Hi-miler. Your Lightweight might, in its early days, have worn Dunlop T29A Trakgrips as these were fitted initially. Some Lightweights wore Bargrips (like Jeep tyres) but all were in the difficult-to-find 6.50x16 size. At the moment, I don't think it is possible to find brand new tyres from anywhere which have the correct pattern for the Goodyears in that size. They are available in the correct size for 109" LWB Land Rovers and many Lightweight owners fit these or other patterns of 7.50x16. These are OK, particularly given the relatively low mileages most of us do, but the drive isn't quite the same and, of course, nor is the reading of the speedometer as they are 2" larger in diameter.

As critical as size of tyre is the size, particularly the width and off-set of the rim as there are several out there, some of which are too wide and can make your Lightweight technically illegal (the tyres and wheels must not be the widest part of the vehicle) without fitting after-market eyebrows over the wheel-arches and I am sure you don't want to do that. You could fit 6.00x16 which, although expensive, are readily available for ordinary, civilian and early Land Rovers, as these are made by vintage tyre manufacturers. They wouldn't be suitable, though if you intended to work the vehicle hard - though they were fitted to the pre-pro and prototype Rover 1s and they coped perfectly well during the FVRDE trials as far as I can see. But, I would not advise you to fit anything other than that recommended by the manufacturer - if an accident were to occur I don't know where you would stand legally.

Other contributors here will offer advice on fitting later tubeless tyres measured metrically, but I can't go any further in that direction because I simply don't know anything about them - except you need new wheels as well as the tubed rims will leak air! Equally, if other contributors can add or amend anything I have written above, I'd be very pleased.

dougall
Posts: 4
Joined: Mon Oct 12, 2020 11:30 am

Re: lightweight tyres

Post by dougall » Tue Nov 03, 2020 11:32 am

many thanks fred for the info.

dougall
1972 lwt 47 FL94

Post Reply