And here’s proof that the cover fits now the curved edge has been introduced to Mr and Mrs Hammer and Dolly:

- 91DACBDE-ECE7-45FA-A65E-0681C8DFDA73.jpeg (916.3 KiB) Viewed 2202 times
In the photo below, to the right of the new foot, and just above it - you can see the flange I mentioned which connects to the inner side panel. It was cracked (almost completely off) but has now been welded back on, although I still need to grind off the excess weld:

- 4822BFEA-098D-496F-9C05-E4E3C86CA40A.jpeg (1.32 MiB) Viewed 2202 times
Close up showing alignment. I’m happy with that:

- B791F03A-48D8-48CE-8125-5AA435657528.jpeg (522.73 KiB) Viewed 2202 times
As mentioned above, I also had many an hour playing with the bulkhead facia higher up, which for a few reasons needed to be repaired again. Firstly, I noticed a big crack in the leg on the passenger side near the top, so off came the repaired dash section, and a sizeable piece of the cabin side of the leg, and in went a repair piece. This was then ground down, a new dash repair section cut, bent and welded in, and plenty of swearing about it all. I’m not yet done filling in all the little pin holes and grinding back the welds, so no more piccies yet until I'm happy with it.
While I was at it I decided to redo the facia repair on the driver's side too, as I had never been all that happy with the repair cosmetically. The new one is much neater, and with some dressing of the welds and sanding it should be near invisible. I also began filling in the missing top middle strip of the dash facia, but again it’s not finished yet. It seems to take me hours to do this tedious spot-spot-spot welding, but the results will be worth it I’m sure.
That’s it for now, feels once again like not enough to show for hours and hours of work, but we’re getting there. At least now there are two lips for the top of the footwells to attach to, and clean metal for the side panels to be plug welded to. Hopefully the bulkhead will be a bulkhead shaped thing by next weekend.
Thanks for tolerating my meandering updates,
All the best,
Andy