Had a useful few hours in the garage today. Left in charge of the puppy, so dragged his mat out in front of the garage doors, sat him down and got to work while he slept in the sun.
First off, another useful, though small, milestone - got the front springs fitted.

- Front springs fitted 13 May 17 small.jpg (458.69 KiB) Viewed 1872 times
Then stripped down the rest of the front axle and was really thrilled to find the diff is very good - barely any backlash, teeth like someone from Dallas and no leaks. I will clean it up, paint the outside and stick it on the rear axle out of the way. Steering swivels have clearly been replaced in recent years - not a mark on them and nicely protected by the leather gaiters. The bearings are excellent as well. All the bolts securing the swivels to the axle casing came undone easily - I was having a good day!
Tie rod, not so brilliant - I'll have to go careful removing the TREs as they are rusted solid in the ends. I'm letting them soak overnight in WD40.
And the brake cylinders - my goodness, of the 4 I have now stripped, only one was working properly the others were seized and the colour of the brake fluid... appalling. Still, I have new ones to replace them. Then, a bit of cleaning up of bits in the de-ruster and general workshop fiddling.

- Front brake cylinder 2 small.jpg (573.69 KiB) Viewed 1872 times
Now, can anyone tell me two things? First, where is the hole for the front axle breather pipe in No2 Cross-member? I can't find it anywhere in the old chassis (I suspect the pipe was loose), but it should be big enough to take a grommet. Secondly, what is the grommet for which is shown in the IPC as being on the breather pipe? It is the same kind of grommet as holds the rear brake pipes on each corner of the spring plate (but less the P-clip). It is not for inserting in the chassis and, I can't see any use for it at all as the pipes don't rub anything anyway as they are attached to the brake line (fixed and flexible). I'd be pleased to know.
Fred