Sankey Towing Legalities
Sankey Towing Legalities
I'm not familiar with towing rules & regulations but have seen that modern trailers mostly have:
1. A cable to apply the brakes if the trailer comes off the tow hitch.
2. Some sort of chain arrangement as a back up if the trailer comes off the tow hitch.
What do we need to have by law to tow a sankey on a NATO hitch (and what do people do in reality)?
Cheers,
Chris
1. A cable to apply the brakes if the trailer comes off the tow hitch.
2. Some sort of chain arrangement as a back up if the trailer comes off the tow hitch.
What do we need to have by law to tow a sankey on a NATO hitch (and what do people do in reality)?
Cheers,
Chris
2A - 39 FG 70
- fv1620
- Bake Off Judge
- Posts: 2268
- Joined: Thu Oct 06, 2011 2:16 pm
- Location: GB-CMN (formerly UK91)
- Contact:
Re: Sankey Towing Legalities
Chris also depends on how old you are, type of driving licence.
Clive Elliott
Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.
Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.
Re: Sankey Towing Legalities
Hi Clive,
I'm past 40 now
and passed my test in 1992. I think that means I have the original trailer allowance.
Cheers,
Chris
I'm past 40 now
Cheers,
Chris
2A - 39 FG 70
Re: Sankey Towing Legalities
Hi Chris,
Apart from the obvious Driving Licence requirements, there are some other construction and use regulations which need to be considered. I looked at a trailer parts website and found some of the following information, however don't take this as gospel as regulations can change, always check legality yourself if not sure.
Vehicles after 1998 need to have an "approved" towing hitch. I guess a pre 1998 NATO hitch escapes this requirement? but need to always use the locking hairpin to secure it when towing. Any trailer over 750Kgs needs brakes. Lights - 2 red sidelights, 2 red stop lights required. Number plate needs to also be illuminated. Indicators need to be fitted which flash at between 60 to 120 times per minute. If trailer is more than 1.3 metres wide it requires at least one Fog Lamp. Early Sankey trailers did not have Fog lamps. This is a point which needs to be clarified. I assume that if not part of the original equipment then not required, but if fitted must be in the correct position and function? Anybody have any further info on this point?
Reflective Rear Red Triangles - fitted a minimum of 250mm and a maximum of 900mm from the ground, with a minimum separation of 600mm and no more than 400mm from the sides. There are measurements to specify the position of all lights. (not all listed here).
Current regulations require an in cab indication to tell you that the rear indicators are functioning, either a flashing light or buzzer.
Trailers need to have a Breakaway Cable fitted. I cannot find any reference to the requirement for a separate chain or cable attaching the trailer to the vehicle. I have purchased a plate which bolts between the NATO hitch and the rear cross member with 2 eyes welded to it. (Wolf type and about £8.00 for a land Rover OE part). I intend to attach the Breakaway cable to one eye and a more substantial cable to the other, attached to the trailer, for piece of mind. Not clear if this is a legal requirement though as I mentioned.
I guess this topic must have been discussed before, so if anyone has any more up to date information, or has a different interpretation to my understanding, I am happy to stand corrected.
Regards
Apart from the obvious Driving Licence requirements, there are some other construction and use regulations which need to be considered. I looked at a trailer parts website and found some of the following information, however don't take this as gospel as regulations can change, always check legality yourself if not sure.
Vehicles after 1998 need to have an "approved" towing hitch. I guess a pre 1998 NATO hitch escapes this requirement? but need to always use the locking hairpin to secure it when towing. Any trailer over 750Kgs needs brakes. Lights - 2 red sidelights, 2 red stop lights required. Number plate needs to also be illuminated. Indicators need to be fitted which flash at between 60 to 120 times per minute. If trailer is more than 1.3 metres wide it requires at least one Fog Lamp. Early Sankey trailers did not have Fog lamps. This is a point which needs to be clarified. I assume that if not part of the original equipment then not required, but if fitted must be in the correct position and function? Anybody have any further info on this point?
Reflective Rear Red Triangles - fitted a minimum of 250mm and a maximum of 900mm from the ground, with a minimum separation of 600mm and no more than 400mm from the sides. There are measurements to specify the position of all lights. (not all listed here).
Current regulations require an in cab indication to tell you that the rear indicators are functioning, either a flashing light or buzzer.
Trailers need to have a Breakaway Cable fitted. I cannot find any reference to the requirement for a separate chain or cable attaching the trailer to the vehicle. I have purchased a plate which bolts between the NATO hitch and the rear cross member with 2 eyes welded to it. (Wolf type and about £8.00 for a land Rover OE part). I intend to attach the Breakaway cable to one eye and a more substantial cable to the other, attached to the trailer, for piece of mind. Not clear if this is a legal requirement though as I mentioned.
I guess this topic must have been discussed before, so if anyone has any more up to date information, or has a different interpretation to my understanding, I am happy to stand corrected.
Regards
- longlegslandyman
- Posts: 314
- Joined: Sun Nov 15, 2015 11:54 am
- Location: Herne Bay Kent
Re: Sankey Towing Legalities
From what i gather.
1 your licence must cover you for a trailer.
2 sankey trailer must have working brakes a brake away cable that operates the brakes and locks them on .
3 the rear lights must have the indicators on the outside
4 the number plate has to be in the middle .
Did see it that the nato bradbury hitch is approved and there was a appoval number quoted .
1 your licence must cover you for a trailer.
2 sankey trailer must have working brakes a brake away cable that operates the brakes and locks them on .
3 the rear lights must have the indicators on the outside
4 the number plate has to be in the middle .
Did see it that the nato bradbury hitch is approved and there was a appoval number quoted .
Re: Sankey Towing Legalities
Thanks for all of the above.
I think I meet the following requirements:
Correct licence.
NATO tow hitch with correct pins.
Correct indication in the cab for trailer turn signal.
The trailer has fully working brakes.
I need to sort the following:
Brake away cable - I think I'll have to drill a hole in the lower end of the lever that applies the brakes and fit a cable on that - has anyone done this? I've got one of the wolf plates to fit between my hitch and the cross member to attach the cable to.
Grey areas:
The trailer has all the lights/reflectors etc in the original positions and they all work correctly - however the lightweight doesn't have fog or reversing lights so these can't be operated on the trailer.
Should I fit a safety chain?
I think I meet the following requirements:
Correct licence.
NATO tow hitch with correct pins.
Correct indication in the cab for trailer turn signal.
The trailer has fully working brakes.
I need to sort the following:
Brake away cable - I think I'll have to drill a hole in the lower end of the lever that applies the brakes and fit a cable on that - has anyone done this? I've got one of the wolf plates to fit between my hitch and the cross member to attach the cable to.
Grey areas:
The trailer has all the lights/reflectors etc in the original positions and they all work correctly - however the lightweight doesn't have fog or reversing lights so these can't be operated on the trailer.
Should I fit a safety chain?
2A - 39 FG 70
- fv1620
- Bake Off Judge
- Posts: 2268
- Joined: Thu Oct 06, 2011 2:16 pm
- Location: GB-CMN (formerly UK91)
- Contact:
Re: Sankey Towing Legalities
Well I can find no EMER that required that but most Series 3 EMERs were incorporated into AESPs. In addition SEMIs (Service Engineered Modification Instructions) were incorporated into AESPs 2320-D-100-831.chipbury wrote:Should I fit a safety chain?
SEMI No 6 was the "Provision of towing safety chain attachment bracket" unfortunately there is no description but I suspect it is one of these:
http://www.ebay.co.uk/itm/Landrover-Ser ... Sw~oFXJ1YK
Clive Elliott
Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.
Collecting military technical publications, researching into military vehicle electrical systems, licensed radio amateur since 1964 using microwave bands for tropospheric scatter.
Re: Sankey Towing Legalities
Thanks Clive - I've got one of those in the post!
I'll use it to clip the breakaway cable onto - not sure where I would clip a safety chain on a sankey mind.
I'll use it to clip the breakaway cable onto - not sure where I would clip a safety chain on a sankey mind.
2A - 39 FG 70
Re: Sankey Towing Legalities
You can buy Breakaway cables with either a clevis or a heavy duty key ring going through the cable at the brake end. My local Ifor Williams dealer sells both types. About £3.75 each if I remember. A Breakaway cable is a legal requirement, but I'm not sure if I will bother to fit an extra chain or cable. A NATO hitch system and Sankey towing arrangement really should not be able to come off, as long as the hairpin is in place to prevent the jaw from opening.
I have noticed that there are various subtle differences in the lighting brackets on Sankey's. On my narrow track below, if I add the red triangles I have bought, I will not be able to fit a military number plate in it's original position. Something I wanted to have fitted, and just uncover for show displays. If I use a 2 row military plate, it will stick out and won't look right. Once the trailer is repaired, I'm thinking about making a separate detatchable number plate board which will fit under the towing eye that can be removed for displays.
Still not happy about how to get a 3 row military number plate back in the correct place, and have the red triangles fitted. I may end up fitting them to the same bracket as the Civvy number plate and lights. Will need to measure and check that they meet the Construction & Use regs of course!
Regards
I have noticed that there are various subtle differences in the lighting brackets on Sankey's. On my narrow track below, if I add the red triangles I have bought, I will not be able to fit a military number plate in it's original position. Something I wanted to have fitted, and just uncover for show displays. If I use a 2 row military plate, it will stick out and won't look right. Once the trailer is repaired, I'm thinking about making a separate detatchable number plate board which will fit under the towing eye that can be removed for displays.
Still not happy about how to get a 3 row military number plate back in the correct place, and have the red triangles fitted. I may end up fitting them to the same bracket as the Civvy number plate and lights. Will need to measure and check that they meet the Construction & Use regs of course!
Regards
- Attachments
-
- P1080799c.JPG (497.27 KiB) Viewed 14582 times
Re: Sankey Towing Legalities
To my knowledge there is not a legal requirement for a breakaway chain on a NATO hitch system as the jaw retaining pin meets requirements, it being ex-military, classed vintage having been manufactured before current regulations. This is not the case with most civvy systems which do not employ the jaw hitch retaining pin system.A Breakaway cable is a legal requirement, but I'm not sure if I will bother to fit an extra chain or cable. A NATO hitch system and Sankey towing arrangement really should not be able to come off, as long as the hairpin is in place to prevent the jaw from opening.
Your trailer is the same as mine (32 ET 42) in respect of it's number plate/rear light arrangement. There was only one triangle fitted to the offside, this was the old style as my post Re: Latest Toy - Sankey narrow track 42 ET 39 page 11 - scroll 1/4 way down. I believe this to be legal for ex-military restored as original vintage trailers manufactured before current regulations. You will be able to fit the correct 3 row 6 digit plate.I have noticed that there are various subtle differences in the lighting brackets on Sankey's. On my narrow track below, if I add the red triangles I have bought, I will not be able to fit a military number plate in it's original position. Something I wanted to have fitted, and just uncover for show displays. If I use a 2 row military plate, it will stick out and won't look right. Once the trailer is repaired, I'm thinking about making a separate detatchable number plate board which will fit under the towing eye that can be removed for displays.
I hope this helps but if wrong I will be illegal when my resto is complete and remain so.
Regards
Bob
042Bobf
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.
19HF27 Lightweight FFR ex Gurkha Field Force HQ, various Gurkha Sigs Tps and Comp Ord Depot Hong Kong 1980-1997.
42ET39 Narrow Track Sankey ex BAOR 22 & 7 Sig Regts, 16/5 Lancers, 2 RTR, 9/12 Lancers & QDG 1969-2001.